1.4571 Steel Plate Flange EN1092-1 TYPE 01 X6CrNiMoTi17-12-2 Material
Contact me for free samples and coupons.
Whatsapp:0086 18588475571
Wechat: 0086 18588475571
Skype: sales10@aixton.com
If you have any concern, we provide 24-hour online help.
xMaterial | 1.4571 | Type | Plate Flange |
---|---|---|---|
Standard | EN1092 Type 01 | China Material | X6CrNiMoTi17-12-2 |
High Light | 1.4571 Steel Plate Flange,X6CrNiMoTi17-12-2 Steel Plate Flange,EN1092-1 Steel Plate Flange |
1.4571 Steel Plate flange EN1092-1 TYPE 01 Steel Material : X6CrNiMoTi17-12-2
Grade : | X6CrNiMoTi17-12-2 | ||||||||||||||||
Number: | 1.4571 | ||||||||||||||||
Classification: | Austenitic stainless steel | ||||||||||||||||
Density: | 8 g/cm ³ | ||||||||||||||||
Standard: |
|
1.4571 Steel Plate flange Chemical composition % of steel X6CrNiMoTi17-12-2 (1.4571): EN 10088-2-2005
Ti = 5 * C to 0.7 Particular ranges of sulphur content may provide improvement of particular properties. For machinability a controlled sulphur content of 0.015 % to 0.030% is recommended and permitted. For weldability, a controlled sulphur content of 0.008 % to 0.030 % is recommended and permitted. For polishability, a controlled sulphur content of 0.015 % max is recommended. Elements not listed in this table shall not be intentionally added to the steel without the agreement of the purchaser except for finishing the cast. |
C | Si | Mn | Ni | P | S | Cr | Mo | Ti |
max 0.08 | max 1 | max 2 | 10.5 - 13.5 | max 0.045 | max 0.015 | 16.5 - 18.5 | 2 - 2.5 | max 0.7 |
1.4571 Steel Plate flange Mechanical properties of steel X6CrNiMoTi17-12-2 (1.4571)
Rm - Tensile strength (MPa) (+A) | 500-700 |
Rm - Tensile strength (MPa) (+AT) | 500-730 |
Rm - Tensile strength (MPa) (+AT+C) | 810-850 |
Rp0.2 0.2% proof strength (MPa) (+A) | 200-240 |
Rp0.2 0.2% proof strength (MPa) (+AT) | 190-210 |
KV - Impact energy (J) transverse, (+A) | +20° 60 |
-196° 60 |
KV - Impact energy (J) longitud., (+A) | +20° 100 |
A - Min. elongation at fracture (%) (+A) | 30-40 |
A - Min. elongation at fracture (%) longitud., (+AT) | 35-45 |
Nominal diameter (mm): | 2 - 50 |
Z - Reduction in cross section on fracture (%) | 60-65 |
Brinell hardness (HB): (+A) | 215 |
Brinell hardness (HB): (+AT) | 210 |